IBM DOS / WINDOWS Driver InstallationChapter 3

Notice – Changes Not Saved

This dialog box will appear whenever you select Custom Install, change some of the parameter settings, and then decide not to save them. It is basically warning you that the changes have not been saved and the default settings have been retained. When you press [ESC] you will be returned to the Main Menu, with QUICK INSTALL highlighted.

Pioneer CD-ROM Installer Ver 2.0

Figure 16 - DOS/WINDOWS - NOTICE Changes Not Saved

Installing More Than One Pioneer CD-ROM Drive

Installing Two Pioneer CD-ROM Changers on one SCSI Chain

Two Pioneer Changers can be installed on one SCSI chain by using the Pioneer device drivers for IBM-PCs and compatibles that ship with the unit. Use a Centronic 50 Pin SCSI cable to connect the two drives. Make sure the drive in the middle of the chain is not terminated and the last drive is terminated. Assign each drive it’s own specific SCSI ID number. Then select CUSTOM INSTALL and indicate the SCSI ID numbers of each drive and the number of discs to be accessed by each drive.

You can also enter the SCSI ID numbers of the two units into the Pioneer Device Driver line in the CONFIG.SYS with the /S: switch as indicated in the example below. Also, the /N: switch must be placed into this line to indicate the number of discs (1-6) to access in each unit.

DEVICE = C:\DEV\DRD600.SYS /D:MSCD000 /N:6,6 /S:0,1 /C:CDP

Owner’s Manual / Software Driver Installation Guide

3-13