Appendix A Troubleshooting IBM- PC DOS / WINDOWS Installation
|
|
|
|
|
CDR101 Not ready |
|
|
| This means the drive has failed to |
reading drive D |
|
|
| |
|
|
| read the disc. | |
|
|
|
|
|
|
|
|
|
|
1. Verify that discs are in the player label side down. Also check to make sure the discs are not seriously scratched and that they do not have a lot of finger prints on them. If the discs have finger prints on them, they can be cleaned by drawing a soft cloth from the center hole to the edge of the disc; never use a circular motion. Excessive scratches may make the disc unreadable.
2. Make sure that the MSCDEX is loading into the Autoexec.Bat
properly. It should be loading first, and it should not be REMARKed out.
3. Make sure that the MSCDEX label in the Config.Sys matches the label in the Autoexec.Bat. It often reads /D:MSCD000 or /D:MSCD001.
4. Reboot the computer and look for more error messages on boot up. Use the PAUSE key to stop the screen and any key to continue. Look for details regarding specific errors in this Appendix.
5. Look carefully at the Inquiry ID=0 line on
6.Try accessing different discs. If the changer is still not reading the discs, it is possible it is having a mechanical problem. Refer to TB #168 and see instructions for running a
Owner’s Manual / Software Driver Installation Guide |