Chapter 3

IBM DOS / WINDOWS Driver Installation

 

 

Calling MPC within Windows

This program can also be used in Windows. Run the Program Manager and open the MS-DOS Prompt icon. Read instructions and press <ALT+ENTER> to open a DOS window within Windows. This window can be moved and made smaller.

Within that Window, press <ALT+ HYPHEN> to bring up MPC. Press <ESC> at any point to put MPC away. Type [EXIT] to return to Windows.

MPC for DOS Error Message:

“Device Driver Not installed. MPC Program is not resident”

MPC.COM will not install if the device driver is not installed or if the /C:CDP switch has not been included in the Pioneer device driver line. Check the Pioneer device driver line in the CONFIG.SYS to make sure that the Pioneer driver has been loaded and make sure the /C:CDP switch is at the end of the device driver line. Install the driver if it has not been installed, and/or type in /C:CDP at the end of the device driver line, if it is missing.

Failure to Remove MPC Program

If, for some reason, the MPC program is not removed When you type

C:\Pioneer\MPCRMV.COM, don’t worry. The next time you boot up our machine it will not appear.

3-16

Software Driver Installation Guide / Owner’s Manual