Troubleshooting IBM- PC DOS / WINDOWS Installation Appendix A

Cartridge will not

eject from the

Changer

1.There are two possible causes of this symptom. One is that the software has locked the magazine into the machine and will not let the user eject it. The other is that the user has set the last DIP switch UP/ON so it has disabled the EJECT button on the front panel.

2. In either case, to remove the magazine, make sure the last DIP switch is DOWN, then turn the Pioneer Changer OFF and back ON. This should allow the front panel EJECT button to work. NOTE: The DRM-602X provides a light on the front panel of the unit that indicates if the EJECT button is disabled, locking the magazine.

3. If a disc tray is stuck, refusing to allow the magazine to eject, contact Pioneer Technical Support or Pioneer Service.

The drive always inserts the first or the same disc, no matter which disc the software has been instructed to use

1. Use the most current version of the driver. Current Pioneer CD-ROM Changer drivers are available on the Pioneer Electronic Bulletin Board.

See Appendix E, Pioneer Technical Resource Numbers

2. Contact ASPI interface card manufacturer for information about ASPI Manager Switches. The ASPI Manager may require /L: statement or /ET: statement to enable a number of logical units.

3.The software package was probably written to work with a single CD-ROM. Try placing the disc in the first slot and then re-install the application. If this works, contact the software manufacturer to see if a version of the software exists that supports multiple sub-units.

A-10

Software Driver Installation Guide / Owner’s Manual