Chapter 4 | MACINTOSH Driver Installation |
| |
Macintosh Driver Installation
Inspection Checklist / Installation Overview
Insert the 3.5” PIONEER Macintosh diskette that ships with the Pioneer CD-ROM Changer into the floppy drive of your Macintosh Computer. Double click on the PIONEER diskette icon. You will see these icons:
Figure 17 - Macintosh Installation Diskette
NOTE: The CD-ROM Folder contains: CLD Access, Apple CD-ROM, CLD Remote, CLD Remote Read Me, Foreign File Access, Audio CD Access, ISO 9660 File Access, High Sierra File Access and Apple CD-ROM driver v 5.0.1.
Do not remove any of the files from this folder. Follow instructions for installation for System 7.0 and above on page 4-3. Leave all of the files in these folders, so the installer can run properly. The 6.0.7 Folder contains only CLD Access 1.2. To install drivers for System 6.0.7 and below see pg 4-4.
With SYSTEM 7.0 and Above
Double click on the Installer to automatically install the required files into System
7.0or above. Files required are contained in CD-ROM Folder. This complete folder must be present on the diskette, for a successful installation. See next page.
With SYSTEM 6.0.7 and Below
If you are running System 6.0.7 or below, double click on the 6.0.7 Folder. Click on the file “CLD Access 1.2” and drag it into the System Folder. Open the CD-ROM Folder by double clicking on it. Then highlight these four files by clicking on them and holding down the SHIFT key: Foreign File Access, Audio CD Access, ISO 9660 File Access, High Sierra File Access. Drag these four files into the System Folder. Power-ON the Pioneer CD-ROM drive and then Power-ON the Macintosh. Access a CD-ROM disc mounted on the desktop by double clicking on its icon. For details see page 4-4.
Owner’s Manual / Software Driver Installation Guide | 4-1 |
