2.Loosen the shipping screws
With the front access panel open, loosen the two screws located in the base
• Screws are permanent to avoid becoming lost but must be loosened to operate the Changer
• Tighten these screws before moving or transporting the Changer
• Closing the front and/or rear access panels cause the Changer to return to the initial default position thus leave access panels open to continue with the installation process
3.Install the drive units
No tools are required to install a drive. While drives may be installed in any of the rear bays (bay 1 through bay 8), the connector board shipped with the Changer is configured for drives to be installed into bay 1 and bay 2.
• Specify the SCSI IDs and set the termination switches on the back of the drives before installing the units
• Verify that the drives are mounted on the guide rails
• Listen for the clicking sound as the drive is pushed into the bay
• Push the drive in until the lock lever on the drive shifts to the locked position
4.Connect the power cord from the Changer to the drive.
•Verify that the wiring monitor indicator on the rear of the drive lights as orange
•Check that the termination indicator is green if the Termination Switch is
ON
- 12 -
