•Two drives installed on separate cables
•Both drives are connected to the internal
To install three or more drives or to use more than one SCSI bus (to increase data transfer rates), it is necessary to purchase additional SCSI boards and cables.
The following factors are key in selecting the appropriate components for your system.
•Types and numbers of drives and the bays to be used
(installing nine or more drives requires installation of an additional power supply)
•Positions where SCSI boards will be installed
(the Changer is equipped with an internal
•SCSI ID to be assigned to each drive
(a SCSI ID may not be assigned to two or more drives on the same bus)
•Cable layout between the various drives and the SCSI boards
(refer to the Installation chapter, Examples of SCSI Cable Connections)
•Which drives will be terminated
(which drive will be at the end of the SCSI chain thus has the termination switch turned ON)
The
An additional power supply must be added in order to install up to eight devices in the upper rear bays (bay 9 through bay 16). The maximum power consumption for the upper bays is equal to that of the lower bays.
WARNING: Use
2.7Products Provided with the DRM-7000
The following components are included with the original shipment of the Pioneer
•
A single
•SCSI Drive Cable (1)
cable compatible with the market standard
•Power Cord
•Placement Fixtures (set) Set includes 4 brackets
•Chassis Keys (2)
-5 -