Pioneer DRM-7000 operating instructions Config S e t u p b r o w s e r

DRM-7000Operating Instructions

4. Enter the Config submode to select the rear bay.

(Config)

S e t u p b r o w s e r

Press the Enter button

M a g a z i n e - b a y o r

R ear (drive) – bay?

Select Rear and press Enter

Bay # 1 =	D r i v e 1
DVDROM	DVD-D7563

5.Scroll (Up and Down arrow buttons) to select the drive/bay for replacement.

Note: If the drive to be replaced has crashed, information might be missing from the following display:

Bay # 3 =	D r i v e 3
DVDROM	DVD-D7563

6.Check the wiring monitor indicator on the back of the drive (orange) is flashing at ½ second intervals.

7.Disconnect the drive cables in the following order:

1 – SCSI Interface cable

2 – Changer Interface cable

3 – Power cable

8.Remove the drive.

It may be necessary to disconnect other drive cables before continuing.

9.Match the drive SCSI ID and termination switch settings.

10.Attach the drive cables in the reverse order of Step 7 above.

1 –Power cable

2 – Changer Interface cable

3 – SCSI Interface cable

Note: Re-connect any other drive cables disconnected during Step 8 above.

11.Verify that the system recognizes the drive.

Bay # 3 =	D r i v e 3
DVDROM	DVD-D7563
Press the Enter button
scsi ID = 3	TermOFF

dev – ID = ********

Note: If the replacement drive fails to be recognized, re-check the cable connections on all drives.

12.Press the Escape button to return to the User mode and close the rear access panel.

-44 -