Pioneer DRM-7000 operating instructions 6.0Optional/Additional Components, 6.1Adding Drives

DRM-7000Operating Instructions

6.0Optional/Additional Components

6.1Adding Drives

Any drive designed for use in the DRM-7000 may be easily added to this system. The power supply shipped with the unit is capable of supporting up to eight additional components. Install the devices in to the lower rear bays (bay 1 through bay 8). To add drives or other components to the remaining rear bays (bays 9 thought bay 16), install an additional power supply.

Touch a separate metallic surface to discharge static electricity before handling a power supply or another component. Avoid any contact between your body and the power supply connections when installing into the Changer.

• Install an add-on connector board if necessary

1. Install the drive unit(s)

No tools are required to install a drive. While drives may be installed in any of the rear bays (bay 1 through bay 8), the connector board shipped with the Changer is configured for drives to be installed into bay 1 and bay 2.

• Specify the SCSI IDs and set the termination switches on the back of the drives before installing the units

• Verify that the drives are mounted on the guide rails

• Listen for the clicking sound as the drive is pushed into the bay

• Push the drive in until the lock lever on the drive shifts to the locked position

- 39 -