DVR645H_WY_EN.book 135 ページ 2006年7月5日 水曜日 午前10時25分

The Initial Setup menu

16

 

 

 

 

Setting

Options

Explanation

 

 

 

 

 

Component Video

Interlace •

Select if your monitor/TV is not compatible with

Out

 

progressive-scan video.

 

 

 

 

 

Progressive

Select if your monitor/TV is progressive-scan

 

 

compatible. Check the operating instructions that

 

 

came with your monitor/TV if you’re not sure.

For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB. If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any picture at all. In this case, press (PLAY) while holding down the (STOP) button on the front panel to switch to Interlace (this also switches Screen Resolution on page 142 to the default setting).

When an HDMI device is connected and Video Priority Mode is set to HDMI, the Component Video Out setting is automatically set to Interlace.

AV1 Out

Video •

Sets the AV1(RGB)-TVSCART output to standard

 

 

composite video (compatible with all TVs).

 

 

 

 

S-Video

Sets the AV1(RGB)-TVSCART output to S-video.

 

 

Recommended if you are using a long SCART cable.

 

 

 

 

RGB

Sets the AV1(RGB)-TVSCART output to RGB. Good

 

 

quality but check your TV for compatibility. Note that

 

 

on this setting signals from the built-in tuner and

 

 

from external inputs is not output when the recorder

 

 

is in TV mode.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on page 160).

The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.

AV2/L1 In

Video •

Sets the AV2 (INPUT 1/DECODER) SCART input to

 

 

standard composite video.

 

 

 

 

S-Video

Sets the AV2 (INPUT 1/DECODER) SCART input to

 

 

S-video.

 

 

 

 

RGB

Sets the AV2 (INPUT 1/DECODER) SCART input to

 

 

RGB.

 

 

 

 

Decoder

Use this setting if you connected a decoder to the

 

 

AV2 (INPUT 1/DECODER) SCART connector. For

 

 

scrambled channels, make sure that the channel

 

 

Decoder setting is set to On. (See Manual CH Setting

 

 

page 134.)

When the Input Line System is set to 525 System, RGB cannot be selected.

Even when set to RGB. depending on the connected device, the input signal may be composite video.

135

En

Page 135
Image 135
Pioneer DVR-545H-S, DVR-645H-S manual Rgb