Pioneer DVR-645H-S, DVR-545H-S manual Playing CDs and WMA/MP3 discs, Playing Video CD/Super VCDs

DVR645H_WY_EN.book 74 ページ ２００６年７月５日 水曜日 午前１０時２５分

07Playback

Playing CDs and WMA/MP3 discs

The table below shows the basic playback

controls for audio CDs1, and WMA/MP3 files.

PLAY Press to start playback.

STOP Press to stop playback.

PAUSE Pauses playback, or restarts

playback when paused.

Except WMA: Press to start scanning. Press again to increase the scanning speed. (There are two scan speeds; the current scan speed is shown on-screen.)

			Press to skip to previous/next
	PREV	NEXT
			track (or folder for WMA/MP3
			disc). (During playback you can
			also use the front panel CH +/–
			buttons.)
			During playback, enter a track
REC MODE
AUDIO SUBTITLE		ANGLE	number then press ENTER to
		PLAY MODE	skip directly to that track.
		CLEAR	Press CLEAR to clear a number
			entry and start again.
		ENTER

Playing Video CD/Super VCDs

The table below shows the basic playback controls for Video CD/Super VCDs.

Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display a menu on-screen from where you can select

what to watch.2

	PLAY		Press to start playback.
			Video CD only: If RESUME is dis-
			played on-screen, playback
			starts from the place last
			stopped.
			Press to stop playback.
	STOP
			Video CD only: You can resume
			playback from the same point
			by pressing PLAY. (Press
			STOP again to cancel the
			resume function.)
			Pauses playback, or restarts
		PAUSE
			playback when paused.
			Press to start scanning. Press
			repeatedly to increase the scan-
			ning speed.
PREV NEXT			Press to skip to previous/next
			track.
			When a PBC menu is dis-
			played, press to display the pre-
			vious/next page. (During
			playback you can also use the
			front panel CH +/– buttons.)

Note

1If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO (SHIFT + 4) button (see Switching audio channels on page 82).

2When playing in PBC mode, some playback features, such as search, repeat and program play are not avail- able. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator (see Using the Disc Navigator with playback-only discs on page 77).

74

En