Pioneer DVR-545H-S, DVR-645H-S manual Connecting up Connecting using Hdmi

DVR645H_WY_EN.book 23 ページ ２００６年７月５日 水曜日 午前１０時２５分

Connecting up

Connecting using HDMI

If you have an HDMI or DVI-equipped1

monitor or display2, you can connect it to this recorder using an HDMI cable (not supplied).

The HDMI connector outputs uncompressed digital video, as well as almost every kind of digital audio.

1Use an HDMI cable to connect the HDMI OUT connector on this recorder to an HDMI connector on an HDMI-compat- ible monitor.

HDMI

IN

HDMI-compatible display

		Y							IN
AC IN
DIGITALAV 1 (RGB) – TV		P	L	AV 2 (INPUT 1/DECODER)			L
OUT	CONTROL	R			R
		P							OUT
	G-LINK	COMPONENT	AUDIO	VIDEO	S-VIDEO	AUDIO	VIDEO	S-VIDEO	ANTENNA
		VIDEO OUT

•The arrow on the cable connector body should be face down for correct alignment with the connector on the recorder.

When connected to an HDMI component or HDCP-compatible DVI component, the HDMI indicator lights.

02

HDMI setup is generally automatic. There are however settings you can change if you need to. See HDMI Output (only available when an HDMI device is connected) on page 142 for more information. Note that the HDMI settings remain in effect until you change them, or connect a new HDMI component.

Important

•An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High- bandwidth Digital Content Protection (HDCP). If you choose to connect to a DVI connector, you will need a DVI to HDMI adaptor cable. A DVI to HDCP connection, however, does not support audio. Consult your local audio dealer for more information.

•The HDMI connection is compatible with 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 16 bit/ 20 bit/24 bit 2-channel linear PCM signals, as well as Dolby Digital, DTS and MPEG audio bitstream.

•If your connected component is only compatible with Linear PCM, the signal is output as Linear PCM (DTS audio is not output).

•If you have connected to a Pioneer plasma display, please select the HDMI setup on the display (refer to the supplied manual for more on this).

Note

1This unit has been designed to be compliant with HDMI (High Definition Multimedia Interface) version 1.2a and HDCP version 1.1. Depending on the component you have connected, using a DVI connection may result in unreliable signal transfers.

2The pixel resolution of this recorder’s HDMI video output is (according to TV format): NTSC (720 x 480i/p, 1280 x 720p, 1920 x 1080i) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i). If your display is not compatible with these resolutions the picture may not be correctly reproduced.

23

En