Pioneer DVR-545H-S, DVR-645H-S manual Pcm, Mpeg PCM

DVR645H_WY_EN.book 137 ページ ２００６年７月５日 水曜日 午前１０時２５分

The Initial Setup menu			16
Setting	Options		Explanation
Audio Out
Dolby Digital Out	Dolby Digital •		Output a Dolby Digital signal when a Dolby Digital
			source is being played.
	Dolby Digital		Convert Dolby Digital sources to Linear PCM output.
	PCM		Use if your connected equipment doesn’t have a
			Dolby Digital decoder.
DTS Out	On •		Output a DTS signal when a DTS source is being
			played.
	Off		Switch off the digital output when a DTS source is
			being played. Use when your connected equipment
			doesn’t have a DTS decoder. In this case, use the
			analog audio outputs.
96 kHz PCM Out	96 kHz	48 kHz • Convert 96 kHz digital audio sources to 48 kHz
			output. Use if your connected equipment doesn’t
			support 96 kHz sampling rate.
	96 kHz		Output 96 kHz digital audio when a 96 kHz source is
			being played.
MPEG Out	MPEG		Output an MPEG audio signal when a source using
			MPEG audio is being played.
	MPEG	PCM •	Convert sources with MPEG audio to Linear PCM
			output. Use if your connected equipment doesn’t
			have an MPEG audio decoder.
Audio DRC	On		Switches on Audio DRC (Dynamic Range Control).
			Use when listening to Dolby Digital material at low
			volume.
	Off •		Switches off Audio DRC.

Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby

Digital.

137

En