DVR645H_WY_EN.book 86 ページ 2006年7月5日 水曜日 午前10時25分

08Playing and recording from a DV camcorder (DVR-645H-S)

During DV recording, if a part of the tape is blank, or has copy-protected material on it, this recorder will pause recording. Recording will restart automatically when there is a recordable signal. However, if there is more than 10 seconds of blank tape, this recorder will stop recording and the camcorder should stop (depending on the camcorder).

For best results when recording from a DV camcorder to this recorder, we recommend cueing the camcorder to the place you want to start recording from and setting the camcorder to play- pause.

1Make sure your DV camcorder is connected to the front panel DV IN jack. Also, set the camcorder to VTR mode.

SHIFT

REC MODE

2 + Set the recording quality.

See Setting the picture quality/recording time on page 59 for detailed information.

3From the Initial Settings menu, check that the DV audio input is setup as you require.

See DV Input on page 136 for more on this.

Check also that the Audio In settings for External Audio and Bilingual Recording are as you want them (see Audio In on page 136).

HOME MENU

4 Select ‘DV’, then ‘Copy from a DV Source’ from the Home Menu.

DV recording only works when the DV camcorder is in VTR mode with a tape loaded.

 

ENTER

5

Select ‘Record to Hard Disk

Drive’ or ‘Record to DVD’.

6Find the place on the camcorder tape that you want to start recording from. For best results, pause playback at the point from which you want to record.

Depending on your camcorder, you can

use this recorder’s remote to control the

camcorder using the , , , ,

, and buttons.

 

 

ENTER

 

7

 

Select ‘Start Rec’.

 

 

 

 

 

 

 

Stop

Stop

 

1.02.22

 

 

 

 

Control with these

Start Rec

 

 

buttons

Pause Rec

 

 

 

 

Stop Rec

 

 

 

HDD

SP (2h00m/DVD)

 

 

 

Rem.

32h45m

 

 

 

 

 

You can pause or stop the recording by selecting Pause Rec or Stop Rec from the on-screen display. You cannot control the camcorder from this remote control during recording.

If you restart recording after stopping the camcorder, the first few seconds of the camcorder tape will not be recorded.

Use the pause button on your camcorder instead and recording will start immediately.

HDD, DVD (VR Mode) and DVD-RAM only: A chapter marker is inserted every time there is a break in the timecode on the DV tape. This happens when the recording is stopped or paused then restarted, for example.

86

En

Page 86
Image 86
Pioneer DVR-545H-S manual Playing and recording from a DV camcorder DVR-645H-S, Select ‘Start Rec’