Pioneer PDP-4270XD manual Watching TV Chapter, Turning the power on, Changing channels

Watching TV

Chapter 6

Watching TV

Important

•Before watching broadcast channels, the built-in TV tuner must be set up. See Setting up TV channels on page 25 for how to do this.

Turning the power on

•To turn on the system, press POWER on the bottom-left of the front of the plasma television.

The POWER ON indicator lights blue.

•To switch the system back into standby, press  on the remote control unit or STANDBY/ON on the plasma television’s control panel on the right-hand side.

The STANDBY indicator lights red.

TV/DTV

•You can then turn on the system again by pressing  or 0 to 9 on the remote control or STANDBY/ON on the plasma television. If you press 0 on the remote control unit, images come from the INPUT 1 source. If you press 1 to 9, TV images display.

•You can also press POWER on the plasma television to turn off the

system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit or STANDBY/ON on the plasma television.

Note

•We recommend not unplugging the plasma television from the power outlet when it is not in use. In standby, the plasma television automatically receives Electronic Programme Guide and DTV Auto Update signals.

•When the system is placed into standby mode, the main power flow is cut and the system is no longer fully operational. A minute flow of power feeds the system to maintain operation readiness.

•If you are not going to use the plasma television for several days, be sure to remove the power cord from the power outlet.

06

English

Plasma television status indicators

The table below shows the operational status of the plasma television. You can check the current status of the system with the indicators on the plasma television.

Indicator status	System status
POWER ON STANDBY
	The power cord of the plasma television has been
	disconnected. Or, the power cord of the plasma
	television has been connected but the POWER button
	of the plasma television is off.
	Power to the system is on.
	The system is in the standby mode.

For other than the above, see Troubleshooting on page 56.

Changing channels

Use the remote control or the control panel on the right-hand side of the plasma television to change channels.

TV/DTV

Channel display

8

AAA

STEREO

10:00

STANDARD

FULL

Switching between the TV and DTV modes

•Press INPUT on the plasma television or TV/DTV on the remote control unit to select the DTV or TV input mode.

21

En