
Preparation
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable.
Preparing the remote control unit
Inserting batteries
05
English
1
23
4
Ferrite core
1 | Open the battery cover. |
2 | Load the supplied two AA size batteries while inserting their |
respective negative polarity |
Cable tie
To power outlet
AC power cord
As close as possible
Note
•Disconnect the power cord from the power outlet when the plasma television is not going to be used for a long period of time.
Connecting the power cord
Rear view
Europe, except UK and
Republic of Ireland
Power cord 

UK and Republic of Ireland
Place batteries with their terminals corresponding to the (+) and
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an explosion. Be sure to follow the instructions below.
•When you replace the batteries, use manganese or alkaline ones.
•Place the batteries with their terminals corresponding to the (+) and
•Do not mix batteries of different types. Different types of batteries have different characteristics.
•Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.
•Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth.
•The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
•If you will not use the remote control unit for an extended period of time, remove the batteries from it.
•WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL PUBLIC INSTITUTION’S RULES THAT APPLY IN YOUR COUNTRY/AREA.
19
En