05Preparation
Preventing the plasma television from falling over
After installing the stand, be sure to take special care to ensure that the plasma television will not fall over and is stabilized to both the wall and rack.
Stabilizing on a table or rack
Stabilize the plasma television as shown in the diagram using the plastic bands and screws supplied with the optional stand.
Note
•To stabilize the plasma television on a table or rack, use screws that have a nominal diameter of 4 mm and that are at least 20 mm long.
(PDP-LX608G)
15 mm | 4 mm |
8 mm to | 20 mm min. |
Screw 
(M4 x 10 mm)
Wood screw (commercially available, 4 mm x 20 mm min.)
Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides.
Screw
Screw
Wood screw
ScrewScrew
(M4(M4xx1010mmm)) 
Wood screw 
(commercially available, 4 mm x 20 mm min.)
15 mm | 4 mm |
8 mm to | 20 mm min. |
Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides.
Using a wall for stabilization
1Attach falling prevention bolts (hooks) to the plasma television.
2Use strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Use hooks, cords and fittings that are available on the market. Recommended hook: Nominal diameter 8 mm, length 12 mm to 18 mm.
M8
12 mm to 18 mm
1. Hook
2. Cord
Fitting
16
En
