
08Setting up
Power Management (PC source only)
The system will be automatically placed into the standby mode when no signal is received from the personal computer.
1Press HOME MENU.
2Select “Power Control“ (/ then ENTER).
3Select “Power Management“ (/ then ENTER).
4Select “Mode 1“ or “Mode 2” (/ then ENTER).
Power Management
Selections Off (default) | No power management | |
|
|
|
| Mode 1 | • Places the system into the standby mode when |
|
| no signal is received from the personal computer |
|
| for eight minutes. |
|
| • Even when you start using the computer and a |
|
| signal is received again, the system stays off. |
|
| • The system is switched on again by pressing |
|
| STANDBY/ON on the plasma television or on |
|
| the remote control unit. |
|
|
|
| Mode 2 | • Places the system into the standby mode when |
|
| no signal is received from the personal computer |
|
| for eight seconds. |
|
| • When you start using the computer and a |
|
| signal is input again, the system is switched on. |
|
| • The system is switched on again by pressing |
|
| STANDBY/ON on the plasma television or on |
|
| the remote control unit. |
|
|
|
5 Press HOME MENU to exit the menu.
Note
•This function is not selectable when the PC is connected to the HDMI terminal.
36
En