Pioneer SC-07, SC-05 manual Using other functions, Setting the Video options, Video Parameter

13Using other functions

Setting the Video options

There are a number of additional picture settings you can make using the VIDEO PARAMETER menu. The defaults, if not stated, are listed in bold.

Important

• Note that if an option cannot be selected on the

Setting

ASPb

(Aspect)

What it does

Specifies the aspect ratio when analog video input signals are output at the HDMI output. Make your desired settings while checking each setting on your display (if the image doesn’t match your monitor type, cropping or black bands appear).

Option(s)

THROUGH

NORMAL

ZOOM

VIDEO PARAMETER menu, it is unavailable due to

the current source, setting and status of the receiver.

1Set the operation selector switch to RCV, then press

VIDEO PARAMETER.

2Use / to select the setting you want to adjust. Depending on the current status/mode of the receiver, certain options may not be able to be selected. Check the table below for notes on this.

3Use / to set it as necessary.

See the table below for the options available for each setting.1

a.• When set to a resolution with which the TV (monitor) is not compatible, no picture is output. Also, in some cases no picture will be output due to copyright protection signals. In this case, change the setting.

•When AUTO is selected, the resolution is selected automatically according to the capacity of the TV (monitor) connected by HDMI. When PURE is selected, the signals are output with the same resolution as when input (At this time, video signals are only output from the same type of terminals to which they were input).

•This setting is valid for HDMI and component outputs.

b.If the image doesn’t match your monitor type, adjust the aspect ratio on the source component or on the monitor.

Making an audio or a video recording

4 Press RETURN to confirm and exit the menu.

Setting	What it does	Option(s)
V. CONV	Converts video signals for output	ON
(Digital	from the MONITOR OUT jacks for
		OFF
Video	all video types.
Conversion)
BRIGHT	Adjusts the overall brightness.	–10 to +10
(Brightness)		Default: 0
CONTRAST Adjusts the contrast between		–10 to +10
	light and dark.	Default: 0
HUE	Adjusts the red/green balance.	–10 to +10
		Default: 0
CHROMA	Adjusts saturation from dull to	–10 to +10
	bright.	Default: 0
RESa	Specifies the output resolution of	AUTO
(Resolution)	the video signal (when analog
		PURE
	video input signals are output at
	the HDMI OUT connector, select	480p/576p
	this according to the resolution of
		720p
	your monitor and the images you
		1080i
	wish to watch).
		1080p

You can make an audio or a video recording from the built-in tuner, or from an audio or video source

connected to the receiver (such as a CD player or TV).2

Keep in mind you can’t make a digital recording from an analog source or vice-versa, so make sure the components you are recording to/from are hooked up in the same way (see Connecting your equipment on page 15 for more on connections).

Since the video converter is not available when making recordings (from the video OUT jacks) make sure to use the same type of video cable for connecting your recorder as you used to connect your video source (the one you want to record) to this receiver. For example, you must connect your recorder using S-Video if your source has also been connected using S-Video.

Note

1 • All of the setting items can be set for each input source.

• Setting items other than V. CONV can only be selected when V. CONV is set to ON.

2 • The receiver’s volume, Audio parameters (the tone controls, for example), and surround effects have no effect on the recorded signal.

•Some digital sources are copy-protected, and can only be recorded in analog.

•Some video sources are copy-protected. These cannot be recorded.

98

En