Pioneer SC-05 Zone Audio Setup, SR+ Setup for Pioneer flat panel TVs, Flicker Reduction Setup

Other Settings

ZONE Audio Setup

If you’ve made MULTI-ZONE connections (see MULTI- ZONE listening on page 66), you may need to specify your volume setting.

1Select ‘ZONE Audio Setup’ from the Other Setup menu.

4d.Other Setup	4d2.ZONE Audio Setup
A/V RECEIVER	A/V RECEIVER
1. Multi Ch In Setup
	ZONE 2 Volume Level :	Variable
2. ZONE Audio Setup	ZONE 3 Volume Level :	Variable
3. SR+ Setup

4. HDMI Control Setup

5. Flicker Reduction Setup

Exit Return Exit Finish

2 Select the volume level setting of ZONE 2 and ZONE 3.1

•Variable – Use this setting if you’ve connected a power amplifier in the sub room (this receiver is simply being used as a pre-amp) and you will be using this receiver’s controls to adjust the volume.

12

•ON – When the receiver is switched to one of the inputs that use the flat panel TV (DVD, for example), the volume on the flat panel TV is muted so only sound from the receiver is heard.

3Assign any input source connected to the flat panel TV to the corresponding input number.

This matches the receiver’s input source with a numbered video input on the flat panel TV. For example, assign DVD to input-2 if you have connected the your DVD video output to video input 2 on the flat panel TV.

•The Monitor Out Connect should be set to the input that you’ve used to connect this receiver to your flat panel TV.

4d3.SR+ Setup

A/V RECEIVER

PDP Volume Control : OFF

Monitor Out Connect : OFF

Exit Finish

•Fixed – Use this setting if you’ve connected a fully integrated amplifier (such as another Pioneer VSX receiver) in the sub room and want to use that receiver’s volume controls.

With the Fixed setting, the source is sent from this receiver at maximum volume, so make sure the volume is quite low in the sub zone at first, and then experiment to find the correct level.

3When you’re finished, press RETURN. You will return to the Other Setup menu.

SR+ Setup for Pioneer flat panel TVs

Make the following settings if you have connected a Pioneer flat panel TV to this receiver using an SR+ cable. Note that the number of function settings available will depend on the flat panel TV you’ve connected.

See also Using this receiver with a Pioneer flat panel TV on page 70 and Using the SR+ mode with a Pioneer flat panel TV on page 71.

1 Select ‘SR+ Setup’ from the Other Setup menu.

4d.Other Setup	4d3.SR+ Setup
A/V RECEIVER	A/V RECEIVER
1. Multi Ch In Setup
	PDP Volume Control :	OFF
2. ZONE Audio Setup	Monitor Out Connect :	OFF

3.SR+ Setup

4.HDMI Control Setup

5.Flicker Reduction Setup

Exit Return Exit Finish

4When you’re finished, press RETURN. You will return to the Other Setup menu.

Flicker Reduction Setup

• Default setting: 4

The OSD’s resolution can be increased. If you feel the OSD is hard to see, try changing this setting. Note that the resolution in this setting only affects the OSD; it has no influence on the video output.

1Select ‘Flicker Reduction Setup’ from the Other Setup menu.

4d.Other Setup	4d5.Flicker Reduction Setup
A/V RECEIVER	A/V RECEIVER
1. Multi Ch In Setup
	Flicker Reduction :	4

2.ZONE Audio Setup

3.SR+ Setup

4.HDMI Control Setup

5.Flicker Reduction Setup

Exit Return Exit Finish

2Select the Flicker Reduction setting you want.

3When you’re finished, press RETURN.

You will return to the Other Setup menu.

2Select the ‘PDP Volume Control’ setting you want.

•OFF – The receiver does not control the volume of the flat panel TV.

Note

1 If you selected ZONE 2 in the Surround back speaker setting on page 56, you won’t be able to change the volume level.

95

En