2.2OPERATING INSTRUCTIONS
To ensure the food always comes out the very best, follow the preparation instructions for the food you are cooking. Using the best shortening makes the best fried foods. The best shortening will last longer than lower grade shortening and save you money. When not in use the shortening should be cooled and covered to prevent contamination.
CAUTION
The fryer has been installed using restraining devices to prevent accidental tipping or movement. Do not attempt to move the fryer when it has hot liquid in it. Splashing hot liquids can cause severe burns.
WARNING
Water and shortening DO NOT mix. Keep liquids away from hot shortening. Dropping liquid frozen food into the hot shortening will cause violent boiling.
2.2.1Fryer Start-Up
DO NOT START FRYER WITHOUT FILLING WITH OIL!
a.Light the pilot light as described in section 1.5.2.
b.Turn the temperature control knob (thermostat) to the desired temperature setting. This knob is located behind the front doors or on the front control panel.
c.The main burners will light.
2.2.2Melting Solid Shortening
NOTICE
The melting procedure below requires cycling of the fryer. Watch carefully for smoke. If smoke is noticed, the shortening is scorching. To prevent this, decrease the time you leave the burners on.
a.Place the Unitrol valve in ON position.
b.Set thermostat to 150°F.
c.Allow main burners to fire for approximately four (4) seconds.
d.Turn thermostat down until main burners go out.
