Locate your Pitco Frialator warranty and fill in the serial number of the fryer and the date received. You will find the serial number on the plate inside the door. Put your warranty card in a safe place for future reference. DO NOT return the card to Pitco Frialator.
1.2.1Check Your Order
The crate containing the fryer unit will also contain the following:
(2)Pitco Cleaner Sample
(1)Drain Clean Out Rod
1.3ASSEMBLY AND LEVELING
When you receive your fryer, it is completely assembled with the possible exception of the legs (or casters) and the heat shield. In some cases, if you have purchased a
1.3.1Leg/Caster Installation and Adjustment
Installing the legs and leveling the fryer is done with a 7/16" wrench, socket, and a large pair of water pump pliers. The legs/casters must be installed to provide the necessary height to meet sanitation requirements and assure adequate air supply to the burner. Attach the legs by performing the following procedure.
a.Lay the fryer on its side being careful not to damage the flue by pulling on it. Protect the outside of the fryer with cardboard or a drop cloth when laying it down.
b.Attach each leg/caster with the hex head cap screws sup- plied with the fryer. Each leg/caster requires four
c.Mount the screws from the inside of the fryer with the nut on the outside. The nuts have lock washers attached to them, therefore it is not necessary to use lock washers.
d.When all four legs/casters are mounted, stand the unit up being careful not to put too much weight on any one leg/ caster. Adjust the height and level the fryer by adjusting the leveling devices on the leg/caster with the water pump pliers.
e.On units with casters, move the fryer to the desired location and lock the wheels using the locking devices on the sides of the casters.
Adjust Here
Adjust
Here Lock
Un Lock