4.3 Bridge

4.3.1Interface Setup 4.3.1.1 GIGA Bridge

This option allows you to setup the GBE (trunk) bridge interface. From the Bridge menu, click on Interface Setup and then GIGA Bridge. The following page is displayed:

 

GIGA (Trunk) Bridge Setup

Label

Description

Mode

Click on the drop-down list and specify the trunk port to be an Uplink or User

(especially for system stacking).

 

 

 

VID

Type in the default port VLAN ID. Valid value is 1 ~ 4094.

 

 

Max MAC

Type in the maximum number of MAC addresses that can be learned by the giga

bridge port (1 ~ 4096).

 

 

 

 

VLAN setting for the traffic. Includes three drop-down lists:

 

Pri-0 ~ 7: Set the default VLAN priority level.

 

UnTagged/Tagged: Select to untag / tag the outgoing (upstream direction for

 

trunk bridge ports) packets. If UnTagged is selected, a double-tagged packet will

VLAN

leave single-tagged (the outer most VLAN tag is removed) and a single-tagged

packet will leave untagged.

 

no Stack/Stack: Disable/Enable N:1 VLAN stacking (our system adds the

 

default VLAN tag to all the incoming frames through this port).

 

Note: When an untagged frame enters the IDL-2402, it is assigned the default

 

PVID of the ingress (incoming) bridge port and become a single-tagged frame

 

no matter VLAN stacking is enabled or not.

 

 

 

Set Ingress ON: check if the VID of the incoming frame is in the member set. If

Ingress

not in the member set, block the frame.

 

 

Set Ingress OFF: Ingress filter disabled.

 

 

Acc.Frm

Click on the drop-down list and select to accept ALL Frame, only VLAN tagged

frame, or only Untagged frame.

 

 

 

- 84 -