Planet Technology IDL-2402 manual 89

	removed) and a single-tagged packet will leave untagged.
	Pri-0 ~ 7: set the default VLAN priority level.
	no Stack/Stack/TLS: disable N:1 VLAN stacking / enable N:1 VLAN
	stacking (our system adds the default VLAN tag to all the incoming frames
	through this port) / enable TLS (transparent LAN service) so that this bridge
	port becomes VLAN transparent (refer to DSL Forum, TR-101). A
	pre-configured S-Tag is used to encapsulate TLS traffic going through this
	port. That is, an S-Tag (PVID here) will be added to all the upstream frames
	received on this port, and the C-Tags will be the original tags of these
	frames (no C-Tag for untagged incoming frames). On the other hand, the
	S-tag will be removed from all the downstream (outgoing) frames.
	Note: When an untagged frame enters the IDL-2402, it is assigned the
	default PVID of the ingress (incoming) bridge port and become a
	single-tagged frame no matter VLAN stacking is enabled or not.
	Set Ingress ON: check if the VID of the incoming frame is in the member set. If
Ingress	not in the member set, block the frame.
	Set Ingress OFF: Ingress filter disabled.
AccFrm	Click on the drop-down list and select to accept ALL Frame, only VLAN tagged
	frame, or only Untagged frame.
	ON/OFF: to enable/disable isolation. When port isolation is enabled, packets
Isolation	received from a line bridge port (including trunk interface configured as
	user-link) cannot be forwarded to any other line bridge port even for
	broadcasting.
	Click on the drop-down list and select the priority-forcing mode. Options are:
	Disabled: Reserve the original priority of all packets.
	Ingress: Force applying the default VLAN priority value to all the packets
Priority Force	received on this bridge port (so this rule will work on all the
	member-set of this bridge port).
	Egress: Force the priority value of all packets sent out from this bridge port’s
	default VLAN to be the default VLAN priority (so this rule only works
	on default VLAN of this bridge port).
	Both: Combine the rules of Ingress and Egress.
All	Select the check box to copy specified circuit to all remainder circuits in current
	page.
Modify	Click on the radio button to select the bridge port you want to modify. Change
	the parameter values and then click on Modify.
Query	Click on this button to get the most recent data.

- 89 -