Planet Technology IPX-1800N Restart, Revert, PLANET IP PBX user’s manual, Configuration

PLANET IP PBX user’s manual

			settings.
			Click RESTART, and the IP PBX Service will restart completely.
Restart	IP	PBX	Currently active calls will be disconnected immediately. This
			function is rarely required unless the network setting has been
Configuration			changed, or the service operates abnormally without
			problematic configuration could be identified.
			Click REVERT, and IP PBX will erase current IP PBX settings
			and revert configuration back to the factory default. Note the
Revert	IP	PBX	reversion affects IP PBX service only, but not other system
			services such as DHCP, TFTP, and NTP. The backup IP PBX
Configuration			configuration files under TFTP remain intact after reversion, so
			that one can restore to a specific time if a backup file had been
			generated then.

To revert the whole system back to the factory default as much as possible, hold the hardware Reset button for 10 seconds. Since this will wipe out almost everything generated by the user, all system interfaces and services must be configured from scratch again if no appropriate backup configuration could be restored. Note that such reversion will not erase backup configurations and existing voicemails. Backup configuration files could be deleted in the TFTP Service page and voicemails could be deleted in the Maintenance page.

3.6.7Advance

Select Service -> IP PBX Service, and then click the Advance tab to configure IP PBX parameters. After the configuration, go to Service -> IP PBX Service, and click RESTART to activate changes.