Polycom RSS 2000 User’s Guide

Initiating the Endpoint Emulation Software

In general, operational systems of various types are equipped with endpoint emulation software. For example, in Windows operational system, the HyperTerminal is included, which may be used as an endpoint emulation program. For information on how to initiate the endpoint emulation software, please refer to the Operation Guidelines for the operational system you are using. If no endpoint emulation software is included in your operational system, please contact your system administrator to find out how to install such software. On the Windows operating systems, generally, you may initiate the HyperTerminal in the process of Start>Programs>Accessories>Communications>HyperTerminal.

Configuration Parameters for the Port

After initiating the endpoint emulation software, emulation parameters have to be set.

Details are as follows:

￿Port: COM1 (determined by the port in use)

￿Speed: 9600 baud rate

￿Data bits: 8

￿parity bit: N/A

￿Stop bit: 1

Additionally, depending on the actual emulation software, it may be necessary to set some other parameters.

￿Local entering will not echo

￿Settings for DEL and Backspace keys

￿Carriage return/Line feed

￿The endpoint emulation types are Self-Motion and ANSI

Make Settings by Using Commands

When the above-mentioned configurations have been completed and the endpoint emulation software successfully initiated, type Enter to get into the login interface.

Login

When the above-mentioned configurations have been completed and the endpoint emulation software successfully initiated, type Enter to get into the login interface.

Various information of the software and the prompt for entering login password are displayed on the login interface. Please enter your login password and then click Enter.

5

Page 7
Image 7
Polycom RSS 2000 manual Initiating the Endpoint Emulation Software, Configuration Parameters for the Port