Powerware 1085, 685 installation manual Unloading the Battery Cabinet from the Pallet

Models: 685 1085

1 54
Download 54 pages 22.86 Kb
Page 13
Image 13

1. Carefully inspect the outer packaging for evidence of damage during transit.

CAUTION:

DO NOT INSTALL A DAMAGED CABINET. REPORT ANY DAMAGE TO THE

CARRIER. CONTACT YOUR LOCAL SALES OR SERVICE OFFICE IMMEDIATELY.

2. Use appropriate material handling equipment to move the cabinet to a convenient unpacking area. Space is provided between the pallets to insert pallet jack blades on the bottom of the unit.

DANGER:

RISK OF INSTABILITY. DO NOT TILT CABINETS MORE THAN 10 DEGREES

FROM VERTICAL OR THE CABINET MAY TIP OVER.

3. Set each pallet on a firm, level surface, allowing a minimum clearance of 4.6m (15 ft) on each side for removing the cabinets from the pallets.

4. Cut and remove the steel bands around each cabinet.

5. Remove the protective cardboard covering from the cabinets by vertically cutting one corner, using a knife blade no longer than 25 mm (1 in.).

6. Remove the corrugated corner protectors, box, plastic bag, and discard or recycle them in a responsible manner.

CAUTION:

IF YOU CAN SEE DAMAGE IN OR ON A CABINET, DO NOT INSTALL IT. REPORT ANY DAMAGE TO THE CARRIER. CONTACT YOUR LOCAL SALES OR SERVICE OFFICE IMMEDIATELY.

Unloading the Battery Cabinet from the Pallet

The battery cabinet is bolted to a pallet consisting of four angle metal supports secured to laminated plywood/foam cushions. The foam cushions act as shock absorbers for the cabinet during shipment.

1. Remove the doors. Remove the retaining screw located inside each door at the

bottom hinge pivot point, then lift the door off. Save the retaining screws for reinstallation of the doors.

2. Locate the field kit (packed inside of the cabinet). Locate the four 1/2 in. jacking bolts and install them in the threaded holes in the front and rear supports. Place a floor protector underneath each jacking bolt, and screw the bolts down against them. The floor protectors protect the floor from being marred by the jacking bolts.

Powerware 9350 Series 685 and 1085 Auxiliary Battery Cabinets

7

Installation Manual 164201408 Rev. P00 053002

 

Page 13
Image 13
Powerware 1085, 685 installation manual Unloading the Battery Cabinet from the Pallet