Q-Logic 59021-05 Examples The following is an example of the Set Config Port command, effect

B – Command Line Interface		￿
Set Config Command
Examples The following is an example of the Set Config Port command:
SANbox2 #> admin start
SANbox2	(admin) #> config edit
SANbox2	(admin-config) #> set config port 1

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press ’q’ or ’Q’ and the ENTER key to do so.

Configuring Port Number: 1

------------------------

AdminState	(1=Online, 2=Offline, 3=Diagnostics, 4=Down)				[Online]
LinkSpeed	(1=1Gb/s, 2=2Gb/s, 3=Auto)				[Auto	]
PortType	(TL /	GL / G /		F / FL / Donor)	[GL	]
TLPortMode	(1=TLTargetMode, 2=TLInitiatorMode)				[TLInitiatorMode]
ISLSecurity	(Any /		Ours /	None)	[Any	]
SymPortName	(string, max=32 chars)				[Port2 ]
ALFairness	(True	/	False)		[False ]
ARB_FF	(True	/	False)		[False	]
InteropCredit	(decimal value, 0-255)				[0	]
ExtCredit	(decimal value, 0-65535)				[0	]
FANEnable	(True	/	False)		[True	]
LCFEnable	(True	/	False)		[False ]
MFSEnable	(True	/	False)		[False	]
MFS_TOV	(decimal value, 10-20480 msec)				[640	]
MSEnable	(True	/	False)		[True	]
NoClose	(True	/	False)		[False ]
I/O Stream Guard -
	(Suppress RSCN)(Enable / Disable)				[Disable]
VIEnable	(True	/	False)		[False ]
CheckAlps	(True	/	False)		[False ]
Finished configuring attributes.
This configuration must be saved (see config save command)					and
activated (see config			activate command) before it can take		effect.

To discard this configuration use the config cancel command.

B-30 59021-05 A