Q-Logic 59021-05 manual save config, restore

B – Command Line Interface	￿
Config Command

restore

Restores configuration settings to an out-of-band switch from a backup file named configdata, which must be first uploaded on the switch using FTP. You create the backup file using the Config Backup command. Use FTP to load the backup file on a switch, then enter the Config Restore command.

Note: Configuration archive files created with the SANbox Manager Archive function are not compatible with the Config Restore command.

save [config]

Saves changes made during a configuration edit session in the configuration given by [config]. If you omit the configuration name value, the configuration you chose for the Config Edit command is used. The switch supports up to 10 configurations including the default configuration.

Notes If you edit the active configuration, changes will be held in suspense until you reactivate the configuration or activate another configuration.

Examples The following shows an example of how to open and close a Config Edit session:

SANbox2 #> admin start

SANbox2 (admin) #> config edit

.

.

.

SANbox2 (admin-config) #> config cancel

Configuration mode will be canceled.Please confirm (y/n): [n] y

SANbox2 (admin) #> admin end

B-8 59021-05 A