Q-Logic 59021-05 manual Table B-9. Set Config Threshold Parameters Continued, Description

￿			B – Command Line Interface
			Set Config Command
	Table B-9. Set Config Threshold Parameters (Continued)
	Parameter		Description
	Rising Trigger	The event count above which a rising
		threshold alarm is logged. The switch will
		not generate another rising threshold
		alarm for that event until the count
		descends below the falling threshold and
		again exceeds the rising threshold.
	Falling Trigger	The event count below which a falling
		threshold alarm is logged. The switch will
		not generate another falling threshold
		alarm for that event until the count
		exceeds the rising threshold and
		descends again below the falling
		threshold.
	Sample Window	The period of time in seconds in which to
		count events.

zoning

Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table B-10. Set Config Zoning Parameters

Parameter	Description
AutoSave	Enables (On) or disables (Off) the
	saving of changes to active zone set in
	the switch’s permanent memory.
	Changes are always saved in the
	switch’s temporary memory.
Default	Enables (All) or disables (None)
	communication among the switch’s
	ports/devices and the fabric in the
	absence of an active zone set.

59021-05 A B-29