Q-Logic 59021-05 manual Table B-8. Set Config Switch Parameters Continued, threshold

B – Command Line Interface			￿
Set Config Command
	Table B-8. Set Config Switch Parameters (Continued)
		Parameter	Description
	PrincipalPriority		The priority used in the FC-SW-2
			principal switch selection algorithm. 1 is
			high, 255 is low.
	ConfigDescription		The name for the configuration. The
			default is undefined.

threshold

Initiates a configuration session by which to generate and log alarms for selected events. The system displays each event, its thresholds, and sampling interval one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. These parameters must be saved in a configuration and activated before they will take effect. Refer to the ”Config Command” on page B-7for information about saving and activating a configuration. Table B-9describes the Set Config Threshold parameters. The switch will down a port if an alarm condition is not cleared within three consecutive sampling intervals (by default 30 seconds). An alarm is cleared when the threshold monitoring detects that the error rate has fallen below the falling threshold.

Table B-9. Set Config Threshold Parameters

Parameter		Description
Threshold Monitoring Enabled	Master enable/disable parameter for all
	events. Enables (True) or disables (False)
	the generation of all enabled event alarms.
	The default is False.
CRCErrorsMonitoringEnabled	The event type enable/disable parameter.
DecodeErrorsMonitoringEnabled	Enables (True) or disables (False) the
ISLMonitoringEnabled	generation of alarms for each of the
LoginMonitoringEnabled	following events:
LogoutMonitoringEnabled	■	CRC errors
LOSMonitoringEnabled	■	Decode errors
	■	ISL connection count
	■	Login errors
	■	Logout errors
	■ Loss-of-signal errors

B-28 59021-05 A