Q-Logic 59021-05 Install SANbox Manager, SANsurfer Management Suite Disk - Windows Installation

4 – Installation	￿
Installing a Switch

■For Linux:

a.Set up minicom to use the serial port. Create or modify the /etc/minirc.dfl file with the following content:

pr portdev/ttyS0 pu minit

pu mreset pu mhangup

b.Verify that all users have permission to run minicom. Review the /etc/minicom/users file and confirm that the line "ALL" exists or that there are specific user entries.

c.Enter the following command at the Linux prompt:

minicom

■For Solaris:

a.Set up Solaris to use the serial port. Modify the /etc/remote file to include the following lines:

sanbox2:\ :dv=/dev/term/a:br#9600:el=C^S^Q^U^D:ie%$:oe=^D:

b.Enter the following command at the Solaris prompt:

#tip sanbox2

3.Log in to the switch. If fabric security is disabled, account names and passwords are not enforced. Refer to the ”Set Setup Command” on page B-38for information about setting fabric security. The default account name and password are (admin, password).

SANbox2 Login: admin

Password: ********

4.2.5

Install SANbox Manager

You can install SANbox Manager on the Windows, Linux, and Solaris platforms. Your switch was shipped with either a SANsurfer® Management Suite Disk or a SANbox2 Installation Disk. Refer to the following installation instructions that correspond to your situation:

■SANsurfer Management Suite Disk - Windows Installation

■SANsurfer Management Suite Disk - Linux Installation

■SANsurfer Management Suite Disk - Solaris Installation

■SANbox2 Installation Disk - Windows Installation

■SANbox2 Installation Disk - Linux Installation

■SANbox2 Installation Disk - Solaris Installation

4-10 59021-05 A