Q-Logic 59021-05 manual Table B-12. System Configuration Settings, Entry, Description

￿				B – Command Line Interface
				Set Setup Command
		Table B-11. SNMP Configuration Settings
	Entry		Description
	TrapCommunity		Trap community password that authorizes an SNMP agent
			to receive traps. This is a write-only field. The value on the
			switch and the SNMP management server must be the
			same. The default is “public”.
	AuthFailureTrap		Specifies the IP address where a notification is sent in the
			event of an authentication failure.

system

Prompts you in a line-by-line fashion to change system configuration settings. Table B-12describes the system configuration fields. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Table B-12. System Configuration Settings

Entry	Description
Eth0NetworkAddress	Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask	Subnet mask address for the Ethernet port.
Eth0GatewayAddress	IP address gateway.
Eth0NetworkDiscovery	Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
	RARP)
AdminTimeout	Specifies the amount of time in minutes the switch
	waits before terminating an idle Admin session.
	Zero (0) disables the time out threshold. The
	default is 30, the maximum is 1440.
SecurityEnabled	Enables or disables the enforcement of account
	names and passwords.
LocalLogEnabled	Enables or disables the saving of log information
	on the switch.
RemoteLogEnabled	Whether remote logging of is enabled or disabled.
	If enabled, log information is saved to a remote
	host that supports the syslog protocol.
RemoteLogHostIPAddress	The IP address of the host that will receive the
	remote log information if remote logging is
	enabled.

59021-05 A B-39