Q-Logic 59021-05 manual Reset Command, Authority Admin Syntax reset, config configname factory

B – Command Line Interface	￿
Reset Command

Reset Command

Resets the switch and port configuration parameters.

Authority Admin

Syntax reset

config [config_name] factory

port [port_number] snmp

switch (default) system zoning

Keywords config [config_name]

Resets the configuration given by [config_name] to the factory default values for switch, port, alarm threshold, and zoning configuration. This keyword clears all zoning definitions. If [config_name] does not exist on the switch, a configuration with that name will be created. If you omit [config_name], the active configuration is reset. You must activate the configuration or reset the switch for the changes to take effect. Refer to Table B-2through Table B-4for switch, port, and alarm threshold configuration default values.

factory

Resets switch, alarm threshold, zoning, SNMP, zoning configuration, and system configuration settings to the factory default values. The switch configuration is activated automatically. Refer to Table B-2through Table B-6.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to Table B-5for SNMP configuration default values.

switch

Reinitializes the switch. This is the default. This command also closes the Telnet session.

system

Resets the system configuration settings to the factory default values. Refer to Table B-6for system configuration default values.

zoning

Clears the zoning database and deactivates the active zone set. The zoning configuration values (autosave, default visibility) remain unchanged.

Notes The following tables specify the various factory default settings:

B-18 59021-05 A