when you are programming the scanner, or any time afterwards.

You can also set a special search code up that will instantly decode the CTCSS or DCS code on a received transmission. Channels programmed with the search code will receive all traffic on the channel, and will instantly decode and display any CTCSS or DCS code that is found with the transmission. You can then store the found code in the channel memory with one keystroke.

This section of the manual describes the process for configuring a memory channel for CTCSS or DCS operation and manually programming a known code. For more information on using the CTCSS and DCS feature while scanning, see “Using CTCSS and DCS” on Page 50.

To program channel memories for CTCSS or DCS operation, follow these steps:

1.First, enter a conventional frequency. See “Storing Conventional Frequencies” on Page 30.

2.Once you have entered the frequency, press MODE until the desired mode appears in the upper left hand corner of the display. Use CT for CTCSS, and DC for DCS.

3.By default, the search code (indicated with SEARCH in the bottom of the display) is programmed. To program a specific code, press FUNC,

43