clockwise until the noise stops. You may find it necessary to set the control a bit further in the clockwise direction to prevent very weak signals or interference from stopping the scan operation.

Talkgroup ID Hold

You can set your scanner to follow a trunking signal that you want to track during scanning.

While the scanner is stopped on a voice channel (VC appears next to the frequency in the display), hold down TRUNK until ID hold ON appears in the scanner’s display.

To manually activate ID hold mode on a selected ID, enter the ID list, scroll to the desired ID, then press FUNC TRUNK. The scanner will initiate ID hold operation on the selected talkgroup.

When ID hold is activated and the scanner receives a voice channel, the scan indication S at the first digit in the top line changes to H to indicate that the call is being monitored while the scanner is in ID hold.

To release ID hold, press SCAN or

TRUNK.

Turning an ID Sub-Bank On or Off

Follow these steps to turn the ID sub-bank on or off during the program mode:

1.Press TRUNK repeatedly to select the desired sub-bank.

2.Press FUNC then 1 to toggle the sub-bank on or off. The

86