Radio Shack PRO-96 Weather Alert Alarm Demonstration, USING THE DELAY, FUNCTION, Press, seconds whileis active, 6.Press WX to exit the FIPS code entry table.Ô, FUNC, FUNC

SAME Standby

Ô NOTES Ô

•Press WX, then the numeric keys 0-9to quickly review stored FIPS codes. Press L/OUT to toggle lockout status.

•Your scanner can also detect the 1050 Hz weather alert tone when a weather channel is set as the priority channel and weather priority operation is enabled. (see “Programming a Weather Channel as Priority” on Page 41). In this mode all alerts are received. FIPS settings are ignored.

•The scanner sounds an alert or beep when it receives the SAME code. If you do not stop the alert (or beep) for five minutes, the alert stops and the scanner beeps every ten seconds. If the scanner receives a new message after five minutes, it sounds the alert or beep. To stop the sound and ready the scanner to receive a new alert signal before the five minute time out, press any key except LIGHT.

5.Press L/OUT to lock out or enable specific FIPS entries.6.Press WX to exit the FIPS code entry table.Ô

7.Press FUNC, and then WX to initiate SAME standby. The scanner will monitor the selected weather radio station for alerts with FIPS codes that match the codes you entered in the FIPS entry table. To exit SAME standby, press FUNC, and then WX.

Weather Alert Alarm Demonstration

To hear the SAME weather alert alarms, press WX for more than 2seconds whileis active.

The display indicates the type of message, and the scanner sounds the alarm associated with that type of message. The alarm sound changes automatically every 3 seconds.

Press any key except LIGHT to end the alarm demonstration mode.

USING THE DELAY

FUNCTION

You can configure your conventional, non-trunked channels for a 2 second delay to avoid missing reply traffic on the same channel. When delay is set for a conventional channel, the scanner will pause for reply traffic before resuming the scan operation.

66