Rancilio Millennium manual ADJUSTMENT AND SETTING OF THE DOSE where available, Heating a beverage

Continuously move the jug up and down so that the nozzle moves in and out of the milk, causing it to froth.

Turn off the steam tap and pour the milk into the cup.

Immediately after carrying out this operation, clean the spout with a sponge or a clean cloth so that the milk does not dry on it. Be careful as the spout is hot and may burn your hand.

8.3. Heating a beverage

Immerse the steam spout into the liquid to be heated.

Gradually turn on the steam tap 7 Fig.8; the steam that bursts in the liquid heats it to the desired tem- perature.

Turn off the steam tap when the desired tempera- ture has been reached.

Immediately after carrying out this operation, clean the spout with a sponge or clean cloth. Be careful as the spout is hot and may burn your hand.

8.4. Preparing tea, camomile, etc.

Place the jug under the hot water spout and use the delivery control according to the model (Fig.8). When the desired quantity has been obtained, turn off the switch.

Add the beverage desired.

Models SDE

For these models, hot water is dispensed in specific measures (see paragraph 9, adjusting the dose of hot water).

To dispense hot water in different quantities, proceed as follows:

Hold down the delivery control 4-E Fig.8 for at least four seconds then release the button; the machine continuously delivers water.

When the desired measure has been obtained, press the button E again to interrupt delivery.

When the dose of hot water is being delivered electronically, delivery can be interrupted by pressing the button E.

When purified water is used, these beverages often assume a darker colour.

Should the user prefer a lighter coloured drink, draw fresh water from an ordinary tap and proceed with the heating phase as described in point 8.3.

9.ADJUSTMENT AND SETTING OF THE DOSE (where available)

9.1. Models SDE

It is possible to adjust the dose of coffee and hot water dispensed by electronically controlled models.

9.1.1. Adjusting the dose

The quantity of coffee and hot water dispensed can be adjusted using the button panel or the hot water controls.

1Press the button E on any button panel and hold it down for 8-10 seconds until water stops flowing from the dispensing unit and the led of the continuons button on the first button panel on the left begins flashing.

2It is necessary to act as to make 1 or 2 cups in order to reach the correct coffee amount adjustment in the cup.

3Put the filter-holder (with ground coffee) on the left unit and the cup under the spout.

4Operate the selected button (i.e. button A for one small cup).

5One the required coffee amount in the cup has been reached, press the stop button E. Coffe will stop pouring and the microprocessor will store the dose.

6Press the continuous button E again; the led will go out and the machine will store the new quantity.

7Make the coffee and check the cup amount in order to check that programming is correct.

If some doses have to be changed (B-C-D), once at point 5 repeat the instructions in points 3-4-5 for each dose, remembering to use the filter-holder with relevant filter and freshly ground coffee.

Then carry out point 6 and repeat point 7 to check all changed doses.

If all units are to be programmed with the same doses, the selection of coffee doses is finished. If the dosage of another unit is to be changed (1-2-3-4 doses), proceed as indicated in the above-mentioned point 1-7, using only the button panel of the selected unit.

9.1.2.Adjusting the quantity of hot water

Proceed as follows:

1Press the continuous E button on any button panel and hold down for 8-10 seconds until water stops flowing from the dispensing unit and the led of the E button on the first button panel on the left starts flishing. The machine is ready to accept quantity variations.

65