.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 22
Assembly (continued)
WARNING: Table extensions must be installed. Front edge of table and extensions must be lined up. An uneven front edge can twist the fence guide bar. Twisted guide bars can misalign fence. A misaligned fence can cause binding or kickback. You could be hit or cut.
6.Tighten a “C” clamp over the edge of table and extension at the center until the extension is even with the table surface as shown. Tighten the two center nuts with a 1/2" wrench.
7.Repeat steps 5 and 6 to align the other extension.
"C" Clamp
Checking Table Insert
WARNING: To reduce the risk of injury from accidental start, make sure switch is “OFF” and plug is not connected to power source outlet.
1.Insert should be flush with table top. Check as shown. Loosen flat head screw that holds insert and adjust the four set screws as necessary. Tighten flat head screw. Do not tighten screw to the point where it bends the insert.
CAUTION: Insert must be even with the table surface. Inserts too high or low can let the workpiece “snag” or catch on uneven edges. Workpiece could twist and kickback.
Table Insert
Set
Screws
3/32" Hex
"L" Wrench
2. To remove insert.
a. Make sure saw is off and unplugged.
b. Loosen flat head screw.
c. Lift insert from front end, and pull toward front of saw.
d. To replace insert.
e. Make sure saw is off and unplugged.
f.Place insert into insert opening in table and push toward rear of saw to engage spring clip and until keyslot in insert will drop over flat head screw. Tighten screw.
g.Do not tighten screw to the point where it bends the insert.
Flat Head
Screw
22
