RIDGID TS3650 manual Storage Hooks Conveniently holds rip fence, Miter gauge when not in use

.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 45

D. These lines indicate the “path” of the cut (kerf) made by the sawblade.

E. When cutting the workpiece, line up mark on workpiece with line on disk.

NOTE: When the blade is changed, or a dado/molding head installed these lines will need to be erased and reset.

Using Ind-I-Cut

12.Micro-Adjust Rip Fence...allows the operator to accurately adjust the rip fence using only one hand. To move the fence push in on the micro- adjust knob and rotate.

The microadjust mechanism may be converted to operate on the left hand side of the fence. Simply remove two Phillips head screws - rotate the micro adjust mechanism 180° and reinstall screws.

13.Herc-U-Lift™ Caster Opera-tion The caster set is activated by pressing down on the metal platform. This will raise the table saw and allow the saw to be moved to desired location.

To lower the table saw, press down on the foot pedal. Make sure the saw firmly rests on the floor. Adjust the rubber leveling feet if necessary.

14. Storage Hooks

Conveniently holds rip fence and	Miter	Rip
miter gauge when not in use.
	Gauge	Fence

45