.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 21
Assembling Table Extensions
1.From the blister pack locate the following hardware: (Quantity indicated is for two extensions)
8Hex Head Screws,
NOTE: Assemble with saw upside down.
WARNING: Stock table exten- sions must be installed. They help support the fence guide bars. An unsupported guide bar can twist. Twisted guide bars can misalign fence. A misaligned fence can cause binding or kick- back. You could be hit or cut.
2.Insert four (4)
3.Repeat step 2 to install the other extension.
4.Stand saw upright on legs. Roll saw over onto front then up onto feet.
WARNING: The saw is heavy. To reduce the risk of back injury, get help to lift the saw. Hold the saw close to your body. Bend your knees so you can lift with your legs, not your back.
5.Line up the front edge of extension with the front edge of the table. At the spots marked “X” in the drawing, tighten a “C” Clamp over the edge of table and extension. Use a combination square to check the alignment of the front and top edges nearest the “X”’s. Tighten the two corner nuts only with a 1/2" wrench.
NOTE: This assembly may also be done without the use of a “C” Clamp.
Hex Head Screw
With Washers
Hex
Screw
With
Washers
"C" Clamps
Align Front Edges
21
