Roland JUNO-D owner manual Creating a patch Patch mode, How to make the patch settings

Creating a patch (Patch mode)

To create a sound (patch) of your own on the JUNO-D, you will start with one of the existing patches (preset patches), and edit it to create the desired sound. A sound you create can be saved as one of 128 user patches.

Each item that can be set is known as a parameter. When you change the values of parameters, you are doing what is referred to as Editing.

Settings for the internal effects (reverb, chorus, multi-effect) are also saved as part of the patch settings. For details on editing the effect settings, refer to “Adding effects” (p. 65).

This chapter explains the procedures used in creating patches, and the functions of the patch parameters.

If you want to edit the sound of a rhythm set, refer to “Creating a rhythm set (Patch mode)” (p. 52).

Three tips for editing patches

Select a patch that is similar to the sound you wish to create (p. 20).

It’s hard to create a new sound that’s exactly what you want if you just select a patch and modify its parameters at random. It makes sense to start with a patch whose sound is related to what you have in mind.

Choose the tone that you want to edit (p. 26)

You can assign a different instrumental sound to each of the two tones (upper/lower) in a patch, and edit them independently. Use [DESTINATION TONE] to choose the tone to be edited; UPPER only, LOWER only, or both.

If the [KEY MODE] is SINGLE, the upper tone will always sound. If you want to hear only the lower tone while you edit, switch [KEY MODE] to DUAL, and turn the PATCH MODIFY section’s BALANCE knob all the way to the “L” position.

Turn Effects off (p. 65).

Since the JUNO-D’s effects have such a profound impact on its sounds, turn them off to listen to the sound itself so you can better evaluate the changes you’re making. Since you will hear the original sound of the patch itself when the effects are turned off, the results of your modifications will be easier to hear. Actually, sometimes just changing effects settings can give you the sound you want.

How to make the patch settings

Including the parameters that can be controlled from the panel, a patch consists of the following types of settings.

•Settings used by the entire patch (Patch Common)

•Settings for each patch (Patch Tone)

Collectively, these are referred to as “patch parameters.”

Changing the way that the tones are sounded (Key Mode)

fig.r03-03a

On the JUNO-D, the sound of each patch is produced by combining two tones; the upper tone and the lower tone (p. 40). The [KEY MODE] setting lets you specify how these two tones will be sounded when you play the keyboard.

This setting is also valid when using Patch Audition. SINGLE: The upper tone is played by all keys on the

keyboard.

SPLIT: The keyboard will be split; the lower range plays the lower tone, and the upper range plays the upper tone.

You can change the point at which the lower and upper tones are divided (p. 45).

DUAL: The upper and lower tones are layered.

Editing the patch parameters

1.Press [PATCH] so it is lit and you are in Patch mode.

2.Select a patch.

3.Press [PARAM] so it is lit.

Now you can edit the patch parameters.

Use PAGE/CURSOR [ ]/[ ] to select the parameter that you want to edit.

“Selecting patch parameters” (p. 45)

fig.r03-04_40

4.If there is an editable parameter, the cursor (underline) will blink below its value. Now you can use VALUE [-]/[+] to

modify the value of that patch parameter.

fig.r03-05.e

cursor

44