Roland JUNO-D owner manual Parameter list, Patch parameters, Patches

Parameter list

Patch parameters

Patches

Patch Common parameters (p. 45)

Parameters		Value
Name	Patch Name	space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ ¥ ] ^ _
		` { }
Category		* Refer to “Selecting a patch by category” (p. 20).
Key Mode		SINGLE, SPLIT, DUAL
Patch Level		0–127
Tone Balance		-64 (LOWER) – +63 (UPPER)
Split Point		A0–C8
Split Arp	Split Arpeggio	UPPER, LOWER, BOTH
Solo Switch		OFF, ON, UPPER, LOWER
ModulationDst	Modulation Destination	UPPER, LOWER, BOTH
PitchBend Dst	Pitch Bend Destination	UPPER, LOWER, BOTH
Modify Dest	Modify Destination	UPPER, LOWER, BOTH
		* This is linked with the panel’s [DESTINATION TONE] setting.
ExpressionDst	Expression Destination	UPPER, LOWER, BOTH
Active Exp Sw	Active Expression Switch	OFF, ON

Patch Tone parameters (p. 46)

Parameters		Value
No.	Original Tone Number	0001–0640
Tone Pan		L64–63R
MFX Switch	Multi-Effects Switch	BYPASS, ON
Chorus Send Lvl	Chorus Send Level	0–127
Reverb Send Lvl	Reverb Send Level	0–127
Coarse Tune		-48– +48
Fine Tune		-50– +50
Portamento Sw	Portamento Switch	OFF, ON
Portamento Time		0–127
Velo Sens Depth	Velocity Sensitivity Depth	-64– +63
Velo Sens Ofs	Velocity Sensitivity Offset	-64– +63
Pitch Bend Range		0–24
Filter LFO	Filter LFO Switch	OFF(PCH), ON(FLT)
LFO Rate		-64– +63
LFO Depth		-64– +63
LFO Delay		-64– +63
Cutoff Freq	Cutoff Frequency	-64– +63
Resonance		-64– +63
Attack Time		-64– +63
Decay Time		-64– +63
Release Time		-64– +63

Patch Effects parameters

* The same parameters are also provided for Rhythm sets.

Parameters		Value
Multi-effects group
Type	Multi-effects Type	00 THROUGH–47 FBK RIPPER
---	Multi-effects Parameters	The number of parameters varies depending on the Multi-effects
		Type. Refer to “Setting multi-effects parameters” (p. 68).
Send Lvl to Cho	Multi-effect send level to chorus	0–127
Send Lvl to Rev	Multi-effect send level to reverb	0–127
Ctrl 1	Multi-effects Control 1	Refer to “Setting multi-effects parameters” (p. 68).
Ctrl 2	Multi-effects Control 2	Refer to “Setting multi-effects parameters” (p. 68).
Chorus effects group
Type	Chorus type	CHORUS1, CHORUS2, CHORUS3, CHORUS4, FEEDBACK
		CHORUS, FLANGER, SHORT DELAY, SHORT DELAY(FB)
Pre-LPF	Chorus pre-low pass filter	0–7
Level	Chorus Level	0–127

106