Restoring the factory settings, Factory Reset

Transmitting patch/rhythm set settings from the MIDI OUT connector (XFER to MIDI)

You can transmit the settings of any patch from the MIDI OUT connector. This function can be used to save patch settings on an external sequencer. If you select “DUMP ALL” for the menu, you can transmit all data stored in the user area to an external sequencer.

1.Press [PATCH] so it is lit and you are in Patch mode.

Select the patch or the rhythm set you want to output.

2.Press [UTILITY].

3.Use PAGE/CURSOR [ ]/[ ] to select “4:XFER to MIDI.”

4.Press [ENTER].

Transmitting the settings of currently selected patch

5.Use VALUE [-]/[+] to select “CURRENT PATCH.”

6.Press [ENTER].

The selected patch settings will be transmitted from the MIDI OUT connector.

After the data has been transmitted, the display will indicate “COMPLETED.” This ends the procedure.

Transmitting the settings of a user patch

5.Use VALUE [-]/[+] to select “USER PATCHES.”

6.Press PAGE/CURSOR [ ].

Use VALUE [-]/[+] to specify the first number of the range of

user patch numbers that you want to transmit.

fig.r03-24_40

7.Press PAGE/CURSOR [ ].

Use VALUE [-]/[+] to specify the last number of the range of

user patch numbers that you want to transmit.

fig.r03-25_40

8.Press [ENTER].

The selected patch settings will be transmitted from the MIDI OUT connector.

After the data has been transmitted, the display will indicate “COMPLETED.” This ends the procedure.

Creating a patch (Patch mode)

Transmitting all data stored in the user area

5.Use VALUE [-]/[+] to select “DUMP ALL.”

fig.r06-77_40

6.Press [ENTER].

All data stored in the user area will be transmitted from the MIDI OUT connector.

When the display indicates “COMPLETED,” the transmission operation has been completed.

If you want to restore the stored data into the JUNO-D once again, send the data to the JUNO-D’s MIDI IN. Do not operate the JUNO-D while this data is being received.