Samsung DVD-R155, DVD-R150 Connecting & Setting Up, Connecting the DVD Recorder, TV mode

Connecting & Setting Up

Connecting the DVD Recorder

This section involves various methods of connecting the DVD Recorder to other external components and required initial setting modes.

1.Disconnect the aerial cable from your TV and connect it to

on the rear panel of the DVD Recorder.

2.Connect of the DVD Recorder and the aerial input of your TV using the supplied aerial cable.

3.Use the Video/Audio Cable to connect ANALOG AUDIO OUT(R/L)/VIDEO OUT jacks on the DVD Recorder to the Audio &Video jacks on the TV.

4.Plug in the DVD Recorder and TV.

5.Turn on the DVD Recorder and TV.

6.Press the INPUT SEL. button on your TV remote control until the Video signal from the DVD Recorder appears on the TV screen.

		Wall
To RF IN
		DVD Recorder
RF Cable	or	or
	TV

Other type of connecting the Video output cable

There are several ways to output video signal.

Select one of the following video connecting that best suits you below.

•Case 1 : Connecting to a Video (Composite) output jack

•Case 2 : Connecting to an S-Video output jack

•Case 3 : Component Video output jacks

S-Video, Component video and Progressive Output Modes

•S-Video and Component video output are available only if your TV supports S-Video input or Component video input, respectively. If S-Video or Component video output does not work, check the TV connections and the TV input selection settings.

•Compared to standard interlaced video, progressive scan doubles the amount of video lines fed to your TV, resulting in a more stable, flicker-free, clear image than interlaced video. This is only available with TVs that support progressive scan.

•Progressive Scan Output (576p)

Consumers should note that not all high definition television sets are fully compatible with this DVD Recorder and may cause artifacts to be displayed in the picture, in case of

576 progressive scan picture problems, It is recommended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding our TV set compatibility with this model 576p DVD Recorder, please contact our customer service centre.

Connecting & Setting Up

■The RF cable connection of this DVD Recorder sends only signals of TV.

You must connect Audio/Video cables to watch a signal from your DVD Recorder.

■TV mode

Press the TV/DVD button on remote control, then "TV" appear on Front LED display (or turn off DVD Recorder).

English - 15