●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
●● If the main unit is powered off, the wireless subwoofer will be in standby mode and the STANDBY LED on the upper side will come on after the LINK indicator (Blue LED) blinks for 30 seconds.
●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption.
●● The transmission distance of the wireless signal between the main unit and subwoofer is about 10 m, but may vary depending on your operating environment. If a
●● If the main unit doesn't make a wireless connection, follow steps
●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.
●● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.Attaching the Toroidal Ferrite Core to the Soundbar Power Cord
You can reduce noise caused by electromagnetic radiation by fitting the ferrite core to the your Soundbar power cord.
Unlock and open the ferrite core.
<Soundbar Power Cable>
Wind the Soundbar power cable around
the ferrite core twice. (Start winding 5 to
10 cm away from the core).
Close the ferrite core by pressing it until it