QAlthough a connection has been established, I cannot connect to the Internet.
▶Check the TCP/IP settings.
AIf you cannot connect to the Internet but you are connected to an AP, check if the TCP/IP settings are configured properly.
When you are not connected to an AP, an X mark appears over the ‘Wireless Network Connections’ icon (
) in the Taskbar. If you
When you are connected to an AP, an X mark appears over the “Wireless Network Connections” icon (
) in the Taskbar.
If your network does not support DHCP, you have to manually configure an IP address by asking your network administrator.
In addition, even if your network supports DHCP, the Internet connection may not be available if the DHCP server fails to allocate an IP address to your computer.
QI have configured both wired and wireless connections with the same IP address, but the network connections do not work properly.
AYou cannot use the same IP address for wired and wireless connections. To use only one IP address for both wired and wireless connections, you must disable one of them according to your requirements in Network Connections in the
Control Panel.
QAfter installing the Wireless LAN Setting program, the “AEGIS Protocol (IEEE 802.1x)” protocol appears in the [Local Area Connect Properties] window.
AThe protocol is a security authentication protocol that is automatically installed when the Wireless LAN Settings program is installed and does not affect the program operation.
Q(For Intel PROSet) Although I have turned the wireless LAN off using the Turn Off Wireless LAN button in PROSet, the Wireless LAN LED is still on.
AThis is normal. The Turn Off Wireless LAN button in PROSet just turns off the wireless LAN software. The wireless LAN hardware is not affected by this operation.
