Samsung SF-555P manual If possible, Software paper size settings, Then back on again, Tray again

Problem	Possible Cause and Remedy
Half of the page is blank.	• The page layout is too complex. Simplify the page layout
	and remove any unnecessary graphics from the document
	if possible.
	• The page orientation setting may be incorrect. Change the
	page orientation in the Printer Properties dialogue box.
	• The paper size and the software paper size settings do not
	match. Insert the correct paper into the machine or change
	the software paper size settings.
	• Scaling may be set to less than 100%. Change the Scaling
	setting in the Printer Properties dialogue box.
	• The printer cable specifications may be incorrect. Use or
	replace the cable with an IEEE-1284 rated cable.
Your machine prints the	• The printer cable might not be connected properly. Check
wrong data, or it prints	the printer cable connection.
incorrect characters.	• There may be a problem with the printer driver software.
	Exit Windows and reboot the computer. Turn the printer off
	and then back on again.
	• The printer cable specifications may be incorrect. Use or
	replace the cable with an IEEE-1284 rated cable.
Printing is too slow.	• If using Windows 95/98/Me, the Spooling Setting may be
	set incorrectly. From the Start menu, select Settings and
	Printers. Click your printer icon with the right mouse
	button, select Properties, click the Details tab, and then
	click the Spool Settings button. Select the desired spool
	setting from the available choices.
	• If you are using Windows NT/2000/XP, the Scheduling
	setting may be set incorrectly. From the Start menu,
	select Settings and Printers. Click your printer icon with
	the right mouse button, select Properties, click the
	Scheduling tab. Then, select the desired scheduling
	setting from the available choices.
Scanner is busy receiving	There may be a copying or printing job in progress. When the
or printing data. When the	current job is completed, try the job again.
current job is completed,
tray again.

7.10 Troubleshooting