Samsung SVR-1670 manual Communication To/From the DVR, Setting up for xDSL, Dhcp, DNS1

Chapter 7. Communication To/From the DVR

	Dynamic Host Configuration Protocol (DHCP) manages host addresses on a
DHCP	network. DHCP is used on a LAN with a DHCP server installed. If the LAN has a
	DHCP server and you have enabled this DHCP option, the DHCP server will allocate
	an IP address to the DVR.
	IP Address is used for communication between the DVR and SVM-S1, and is also
IP Addr	used when Web Viewer accesses the DVR. It is available only when Net Mask and
	Gateway are set.
Net Mask	Net Mask specifies a range of IP addresses and enables IP addresses in the range
	to communicate. Net Mask should be allocated by a network administrator.
Gateway	Gateway must be specified to enable IP addresses to communicate and should be
	allocated by a network administrator.
DNS1	DNS1 must be specified to register the DVR to DDNS Server(www.samsungipolis.
	com) while DNS Address should be allocated by a network administrator.
Additional DNS	Additional DNS is used to replace DNS1 when it is unstable or has a problem.
Port	Port is used to register to SWR, connect to SVM-S1, or connect to Web viewer. The
	default port is 4000.
Bandwidth Limit	Kbps sets the maximum transmission speed of data output from the DVR (the
	data transmission capability of the DVR). This can be left blank. Ask your network
(Kbps)
	administrator to specify it when necessary.

Setting up for xDSL

This section discusses the options available if your Network Type is xDSL.

Figure 7.1.2 Network Submenu for the Type xDSL (on the Communication Menu)

Option	Setting
Type	xDSL is the correct setting if the DVR is connected to a PPPoE-type xDSL line.
	(If the xDSL line is not of the PPPoE type, you must select Ethernet.)
User ID	Enter your User ID.
Password	Enter your password.
Bandwidth Limit	This sets the maximum transmission speed of data output from the DVR (the
	data transmission capability of the DVR). This can be left blank. Ask your network
(Kbps)
	administrator to specify it when necessary.
Status	Displays the connection status of the DVR.
Port	Port is used to register to connect to SVM-S1 or to Web Viewer. The default port is
	4000.

Digital Video Recorder 56 User Guide Digital Video Recorder 57 User Guide