SATO CL408-412e manual Dipswitch Settings, DSW1 Default Settings, DSW1 Configuration

Unit 4: Printer Configuration

DIPSWITCH SETTINGS

This chapter identifies the functions of the printer’s integrated dipswitches. The dipswitch complex is located on the printer’s operator panel and is an integral part of its configuration by enabling/disabling various operational features. Refer to the table below on switch designation and their specific functions.

ATTENTION: Each dipswitch must be set for the printer to properly function. Address all eight switches individually, but some may not require change.

NOTE: A small, flat tool similar to a screwdriver is required to alter dipswitch position.

When changing a switch setting, ensure that it has been moved fully up or down.

NOTE: The switches are arranged horizontally, from left to right, and oriented vertically. The ON position is always upward and the OFF position is always downward.

DSW1 DEFAULT SETTINGS

1-1		1-2	1-3		1-4		1-5		1-6	1-7	1-8
OFF		OFF	OFF		OFF			OFF	OFF	OFF	OFF
				DSW1 CONFIGURATION
1-1	Data BIt				OFF			8 Data Bit
					ON			7 Data Bit
				1-2		1-3
1-2				ON		ON		Reserved
	Parity
				ON		OFF		Odd
1-3
				OFF		ON		Even
				OFF		OFF		None
1-4	Stop Bit				OFF			1 Stop Bit
					ON			2 Stop Bit
				1-5		1-6
1-5				ON		ON		Normal: 2400, High Speed: 57600
	Baud Rate			ON		OFF		Normal: 4800, High Speed: 38400
1-6
				OFF		ON		Normal: 19200, High Speed: 19200
				OFF		OFF		Normal: 9600, High Speed: 9600
				1-7		1-8
1-7				ON		ON		Status 4
	Protocol
				ON		OFF		Status 3
1-8
				OFF		ON		XOn / XOff
				OFF		OFF		Ready / Busy

CL408-412e Supplemental Manual 4-3 PN: 9001159A